work condition

Correlations of Transient Emission Test Work Condition for In-use Gasoline Automobile

在用汽油车瞬态排放测试工况的相关性

Based on the indirect fuzzy pattern recognition, the mathematical model for sliding supports selection is established. The best type of sliding support adapted to given work condition is obtained by establishing factor set, evaluating index set and fuzzy relation matrix.

利用模糊模式识别的间接方法，通过建立滑动支承类型选择的模糊数学摸型，确定了因素集、评价指标集和模糊关系矩阵，求得了适合已知工况的最佳支承类型。

It is of importance to obtain optimum preload and ensure the dynamic quality in whole work condition including high torque at low speed and high power at high speed, which is the foundation of preload control.

确定最佳预紧力，实现电主轴在包含低速大转矩与高速大功率整个工作范围内动力学品质全局兼优是预紧力可控的基础。

Frequency conversion air condition system characters continuous regulating refrigerant volume, Consequently air condition system can be optimized to run in various work condition, and season energy effect ratio ( SEER) is enhanced obviously, therefore its control method is a research hotspot in refrigeration field.

变频空调系统具有连续调节制冷剂流量的特性，从而使系统在各工况下均可优化运行，显著提高季节性能比，故其控制方法的研究一直是国内外制冷界研究的热点。

The varying work condition is the most important problem to the underwater thermal engine system which controlled by pressure regulator.

基于压强调节阀控制的动力系统换速问题是决定某水下航行器（如鱼雷）热动力系统安全性的最重要的问题。

According to the work condition of pantograph slider, materials with improved friction wear performance was designed.

根据受电弓滑板的工况条件, 设计了摩擦磨损性能较佳的受电弓滑板材料.

This is a protective action to Germany KUSTER soft calender when normal work condition doesn't reach.

这是德国KUSTER公司在生产条件未满足的情况下,对浮动胶辊采取的一种保护性措施.

The materials and varieties of core wires of ultraviolet-curing wire saw have been selected by technical requirement of the wire saw work condition for material strength.

分析了线锯实际工作对材料强度性能的技术要求，确定了光固化线锯芯线的材料及种类。

The conclusion is that the on-state time of the ESD protection circuit is 380 ns under ESD pulse and the protection circuit does not work in work condition.

结论证明：在ESD脉冲下，该保护电路的导通时间为380ns；

The valve work condition and normal failure are studied in this paper. The heat treatment of 21-4N steel exhaust valve is related to the samdwich separated out. The samdwich affects the valve capability 21-4N steel exhaust valve fatigue fracture is caused by thermal overstress.

本文介绍了气门的工作条件、正常失效及21-4N钢排气门强化热处理与层状析出的关系，分析了层状组织对其性能影响和21-4N钢排气门过载断头失效的原因。

But the work condition get worse with its bad lubrication, fast wearing away of crescent slide, big fit clearance and impaction.

但是由于润滑条件不良、月牙形滑块磨损较快、配合间隙增大，引起冲击，因而又恶化了机械的工作条件。

This thesis on research dynamical loads on rubber transmitting belts used in driving pumping unit with long-stroke, especially the influence of the elasticity on rubber transmitting belts and work condition is discussed. Analysis on improving the SDJ-150 rubber belt conveyer gearing

分析了长冲程抽油机传动胶带中的动载荷，重点讨论了胶带弹性及抽油机工况对动载荷的影响。SDJ-150型胶带输送机传动装置的改进

" If I understand him correctly, Mr. Brake maintains ( that ) workmen are indifferent to work condition. "

如果我更正确的话, 布莱克先生认为工人不关心工作条件.

Discussion about Design of Air Condition Refrigerating System Applying in T3 Work Condition

应用于T3工况的空调器制冷系统设计浅议

Since the fact that the work condition under the shaft in coal mine is comparatively odiously, electric motor block rate is particularly tall.

由于煤矿井下的工作条件比较恶劣，电动机的故障率特别高。

For better adaptability of controlling to the actual work condition, new intelligent controller, that include intelligent switcher, the digital PID and the fuzzy neural network, is given.

为了使控制方式更好的适应实际现场工况的需要，提出了一种带有智能开关的，集数字PID和模糊神经网络PID控制策略于一体的智能控制模型。

Then, the principle of virtual work is used to derivate the equilibrium condition of CM.

在以上基础上, 应用虚功原理,推导出柔性机械稳态的条件.

His work is full of profundities and asides concerning the human condition.

他的作品充满了有关人类境况的深邃见解和话外音。

Considering the work condition and property of the system, time-sharing method was used to measure the downhole parameters.

根据系统工作的实际情况及特点，本测试系统采用分时测量的方法测量井下各参数。

Based on terminal conditions of numeric analysis, numeric analysis of the relative expanding difference of shaft and cylinder of steam turbine was made at the different temperatures in the no-load work condition by ANSYS.

利用数值分析的边界条件，运用ANSYS有限元分析软件，对汽轮机转子及汽缸空负荷工况下，不同排气温度时的相对胀差进行了数值模拟。

Plant store, work condition and maintenance.

工厂厂址 、 环境、设施与维护.

Exploration on Work Condition to Failure mechanism of Engine Exhaust Valve

工况对发动机排气门失效的影响

According to technical requirement of the wire saw work condition, the selection principles of material performances have been brought forward.

根据线锯加工工况对结合剂性能的技术要求，提出了光固化线锯树脂结合剂材料性能的选择原则。

Through the analysis of the work condition of the circuit breaker, summarizes the operation of the common fault circuit breaker when, determined the key monitoring parameters such as points off average speed, route, closing time and opening time.

研究通过深入分析ZN42-27.5型真空断路器的工作状态，总结断路器运行时常见故障，确定了真空断路器分合闸平均速度、行程、分合闸时间等关键监测参数的提取方法。

Combined with the reaction kettle of field work condition put forward and design a series of increasing the white carbon black reaction kettle control measures related to the reliability of the system.

结合反应釜的现场工作条件提出并设计了一系列提高白炭黑反应釜控制系统可靠性的相关措施。

The main work is as follows: Mesoporous SiO2 was synthesized in acidic condition using CTAB as template and tetraethyl orthosilicate ( TEOS) as inorganic precursor, which characterized by scanning electron microscopy and infrared spectrometry.

本论文主要工作如下：1、以CTAB为模板分子，正硅酸乙酯（TEOS）为硅源，在酸性条件下合成出介孔SiO2，利用扫描电镜和红外光谱进行了表征。

There are a mass of factors which affect the testing and the work condition is atrocious.

由于各种人为因素的影响,质量难以保证,并且工人的工作环境恶劣.

Material's heat properties not only are numerical data in deciding whether the material suits for working process or not, but also are the fundamental parameters when analysing concrete heat transferring processes, designing projects, setting the best work condition and manufacturing special processing machines.

农业物料热特性参数不仅是衡量物料能否适应具体热过程工作需要的数量依据，而且是对特定热过程进行分析计算、工程设计、确定机器最佳工作参数及相关加工设备制造的重要参数。

Aiming at the characteristic of passenger vehicle and taking acceleration time and fuel consumption at mixed work condition as evaluation index, the article applies robust response surface method in power train parameters matching of passenger vehicle, its effectivity is further testified by optimization of practical example.

文章针对乘用车使用特点，以加速时间和混合工况油耗作为评价指标，应用双响应面鲁棒设计理论，对乘用车传动系统参数进行匹配优化，并用实例优化表明其有效性。

Abroad work board operational condition makes clear, the job of this respect is very main.

国外创业板运作的情况表明, 这方面的工作非常重要.